Alex99
October 27th, 2010, 03:15 AM
Hi all,
I recently discovered through the AUT-VE process that somehow my commanded AFR won't go leaner than 14.63 although I'm in open loop and have lean cruise cells in my B3647 table. Somehow the tune doesn't reference anything leaner that stoich anymore.
I have been doing normal cal flashing for some days until I noticed this.
Is this a bug in the program or did I enable/disable anything that I'm not aware of.
Here is a recent log and tune.
Should I do a full flash to make sure everthing gets cleaned out?93529353
Thanks
Alex
I recently discovered through the AUT-VE process that somehow my commanded AFR won't go leaner than 14.63 although I'm in open loop and have lean cruise cells in my B3647 table. Somehow the tune doesn't reference anything leaner that stoich anymore.
I have been doing normal cal flashing for some days until I noticed this.
Is this a bug in the program or did I enable/disable anything that I'm not aware of.
Here is a recent log and tune.
Should I do a full flash to make sure everthing gets cleaned out?93529353
Thanks
Alex