map sensor 12615136 reading

[etmotorsports]

This is a really annoying problem. I have the map sensor listed above but and the COS3 installed but it will not read boost on the scan tool. I have calibrated it and it is the same readings at Key on engine off as the stock one. If i apply boost pressure it doesn't read but it will read vacuum.

[etmotorsports]

Has anyone else had this problem, sometimes the sae.map will read the boost and sometimes not....it has to be something i doing on the setup of the scan tool dash board or pid anyone have any ideas.

[joecar]

On the dash tab gauge/chart display, do rightclick->Properties and and set the max value.

Can you post a short log with this sensor...?

[etmotorsports]

I didn't try that joecar but i removed all the pids and then added them back i left off a few maybe those were not allowing it to read, if it happens again i will check the min max on that pid thanks for the tip.

[joecar]

Is this from the scantool or from V2 BBL...?