setting to imperial?

[pavetim]

Is there a way to set the whole tune tool to imperial so if im trying to figure out shift points and mph etc I don't have to run through a conversion?

[joecar]

You will want to set both tunetool and scantool the same (so that scan->tune pid linking works right)...

In scantool:
- go Edit->Properties->Options->Preferred Unit System and click on Imperial, then click Ok.
- goto PIDs tab, do CTRL-A (to select all), do rightclick->Imperial.

In tunetool:
- go Edit->Configure Display Units, click All (to select all), do rightclick->Imperial, click Ok, restart tunetool.