curtbriggs
December 15th, 2010, 04:13 PM
Injector Offset vs. Volts vs. Vacuum on my excel spreadsheet with Injector Flow Rates:
is this the same as B3701 Injector pulse width voltage adjustment?
If so, it's 90*s out with kPa at the top instead of vertical. The vertical on the spread sheet appears to be the volts 4.5 to 20.5 the horizontal at the top is -80 to 80
There are three of these charts, #2 goes from 20 to 180 and #3, the range is 128 to 640. It only has the above title and no lables.
Any one knowledgeable about this and could you please enlighten me.
Also, I tried to attach this spread sheet to this message with manage attachments and I flunked the test. Again!
I thought this spread sheet with ten different injector flow rates and all associated information would be of use to others.
Thanks, Curt
is this the same as B3701 Injector pulse width voltage adjustment?
If so, it's 90*s out with kPa at the top instead of vertical. The vertical on the spread sheet appears to be the volts 4.5 to 20.5 the horizontal at the top is -80 to 80
There are three of these charts, #2 goes from 20 to 180 and #3, the range is 128 to 640. It only has the above title and no lables.
Any one knowledgeable about this and could you please enlighten me.
Also, I tried to attach this spread sheet to this message with manage attachments and I flunked the test. Again!
I thought this spread sheet with ten different injector flow rates and all associated information would be of use to others.
Thanks, Curt