View Full Version : LMM in a "DEAD STATE!" Help
8100 Power
January 3rd, 2011, 11:57 AM
Like I always done, attempted to do a cal flash on a my fathers LMMs to add some power. I've successfully flashed once for a DPF Delete and now it says FAILED: Controller has returned no normal opertaion.
I've tried unhooking batteries. Any suggestions?
8100 Power
January 3rd, 2011, 12:00 PM
With V8 I get this:
Executing: C:\Program Files\EFILive\V8\Config\LMM_R.obj
Virtual machine started
Script loaded
Script verified
Trying standard key
Reading
Script exited with code $0311: Mode Not Supported ($11).
I'm running the latest and greatest software, firmware, and boot.
ScarabEpic22
January 3rd, 2011, 01:18 PM
Um are you trying to read or write? V8 is executing a read operation with that log, if it was writing the Executing line would say LMM_W.obj at the end, not LMM_R.obj.
Have you tried using V7.5 and V8?
8100 Power
January 3rd, 2011, 01:33 PM
I was trying both! Just trying to get it to work. I called Rob and he got me going.
I disconnected the batterys for 30 Mins this time, connected the scan tool and clear codes, etc. Then I was able to full flash the stock tune. Now all is well. I don't know what happen the first time.
I would assume the problem was with V8, as it never did act correctly when I first try to read with it.
Everything worked in V7 though.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.