LMM in a "DEAD STATE!" Help

[8100 Power]

Like I always done, attempted to do a cal flash on a my fathers LMMs to add some power. I've successfully flashed once for a DPF Delete and now it says FAILED: Controller has returned no normal opertaion.

I've tried unhooking batteries. Any suggestions?

[8100 Power]

With V8 I get this:

Executing: C:\Program Files\EFILive\V8\Config\LMM_R.obj
Virtual machine started
Script loaded
Script verified
Trying standard key
Reading
Script exited with code $0311: Mode Not Supported ($11).

I'm running the latest and greatest software, firmware, and boot.

[ScarabEpic22]

Um are you trying to read or write? V8 is executing a read operation with that log, if it was writing the Executing line would say LMM_W.obj at the end, not LMM_R.obj.

Have you tried using V7.5 and V8?

[8100 Power]

I was trying both! Just trying to get it to work. I called Rob and he got me going.

I disconnected the batterys for 30 Mins this time, connected the scan tool and clear codes, etc. Then I was able to full flash the stock tune. Now all is well. I don't know what happen the first time.

I would assume the problem was with V8, as it never did act correctly when I first try to read with it.

Everything worked in V7 though.