View Full Version : Knock sensors
Harrismarine
January 3rd, 2011, 04:34 PM
I see in COS 5 There is an option to change type of knock sensors B1402, Can I use the LS2 type and rewire to 411 pcm as shown?
5.7ute
January 4th, 2011, 03:42 PM
I couldnt get it to work but that isnt saying much. AFAIK the necessary hardware isnt in the pcm to run these sensors properly.
S10Wildside
May 22nd, 2012, 02:20 AM
I couldnt get it to work but that isnt saying much. AFAIK the necessary hardware isnt in the pcm to run these sensors properly.
Keep in mind that the 2002 4.3L S-10 uses the 12200411 PCM and a flat response knock sensor. Because this is true, it must be that all 12200411 PCMs have the hardware for the flat response type knock sensor(s).
dazzak75
August 1st, 2012, 09:47 PM
Just wondering if someone could help on the knock sensors, I realise that the higher the number the less sensitive they are, but what is the mg on the top of the table? where the numbers 100/200/400 etc?
Cheers
darcy
August 1st, 2012, 11:09 PM
Just wondering if someone could help on the knock sensors, I realise that the higher the number the less sensitive they are, but what is the mg on the top of the table? where the numbers 100/200/400 etc?
Cheers
http://forum.efilive.com/showthread.php?19760-What-is-quot-mg-quot-Can-we-log-it
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.