AutoCal Read List

[L31Sleeper]

When I load Options.txt on my AutoCal it only shows the first two PCMs
then copies the second one to the 3,4,5 spot. I don't understand ?

this is what shows up

Read 1
E38
Read 2
E67
Read 3
E67
Read 4
E67
Read 5
E67

even if I select

E38
E67
LS1B
T42
T43

[Tordne]

Can you please email me (support@efilive.com) your Option.txt file?

[L31Sleeper]

Sent

[Tordne]

You're running the latest pre-release firmware right (2.07.06)? This issue didn't happen for me till I updated an AutoCal device this second. Once you confirm firmware for me I'll escalate it as a bug.

[L31Sleeper]

Correct. I ordered it from Justin, updated it and linked it up. I just wanted everything
to be good before I handed it off to my customer.

Thanx
-Justin

[Tordne]

Thanks, I've escalated the issue mow. In the previous firmware there was only Read1 and Read2 options in Basic Menu Mode. The latest firmware has the 5 options so I'm thinking that the cause of the problem is simply going to be in the expansion of the number of Read options.

[L31Sleeper]

SOooo...... there is an Advanced Menu Mode ??

[Tordne]

Yup. In the device settings under Options. There is a selection for Simple or Advanced mode. I wou;dn't recommend sending it to a customer in Advanced Mode, there is just too much more "stuff" there and you support the customer remember ;)

[L31Sleeper]

I tried Advanced mode and I got stuck in the scan tool menu <-Exit wouldn't work.
I had to reboot to get out of it.

[Tordne]

The 'Exit' option in the Scan Tool menu section works fine for me in Advanced menu mode :nixweiss:.

[L31Sleeper]

Sorry I didn't specify......I enter the 'scan tool' menu select the 'select PIDs' menu once I select a PID I can't get back out.

[Tordne]

How about that eh? I've passed that on as well.

[L31Sleeper]

I'll keep looking.......LOL

[L31Sleeper]

Hey Andrew could you shoot me a PM when this is resolved.

Thanx
-Justin

[Tordne]

Both issues have just literally been identified and fixed. They will be included in the next update which we expect to happen i the next few days. We have had no issues reported with the latest pre-release so we'll but putting out a new general release very soon :). Thanks for finding and reporting both issues.

[L31Sleeper]

Hey does the AutoCal "basic menu" clear DTCs or only display them ?

[Tordne]

In Basic Mode only the Read DTCs option is presented.

[Tordne]

We are actually going to add in the option to Clear DTCs in the Basic menu as we all concede that it really should be there. Look for that in the next update also :)

[L31Sleeper]

Any News ? I found out I don't have permission to start a thread on the software update page:hihi::hihi:

[Tordne]

No users do ;)

I'll check with Paul tomorrow when the next update is expected (I thought it was soon).