PDA

View Full Version : Wide band recommendation that plugs into V2



68problemchild
February 13th, 2011, 02:54 AM
Hey guys. I just got the Wideband back for the second time from the manufacturer and still no go. Its the Innovate and still has two short flashes.

V2 wont recognize it.

What other widebands plug right into V2? What would you all recommend? I have given up trying to get this one working. I know the wiring is good since the regular O2 sensor works and reads just fine.

Thanks in advance for all your help.

Tordne
February 13th, 2011, 07:32 AM
I have 2 x LC-1's connected serially. If I was to purchase again I'd be having a look at a dual channel Tech Edge with NTK sensors I reckon.

mr.prick
February 13th, 2011, 10:08 AM
How is your WBO2 wired and are the V2 settings correct for Innovate controllers?

68problemchild
February 14th, 2011, 11:11 AM
Wiring is correct. Pos, Neg, High and low sensor. Pretty basic.

On V2, I think I tried every possible configuration. Reg O2 works great.

Will the tech edge plug right into V2? Any model number? best place to get one?

THanks!

Tordne
February 14th, 2011, 11:23 AM
You will need a serial cable to connect from the TechEdge to the V2 serial input. TAQuickness sells them (http://www.taquickness.com/taqcables.htm).

I'm not aware of any TechEdge resellers. I think you'll just get them direct from Australia (http://wbo2.com/). Looks like either the '3B1 - Pro' or '3H1 - Dual' should work fine.