View Full Version : Tuning help!!!
Juniordiesel
February 19th, 2011, 09:43 AM
Tuning my truck for the first time with DSP2 tune. Keep getting a "error: failed. Controller has returned to normal operation, please retry the operation." However above it in green it says "ECM flash memory erased ok. " it keeps cycling through this. PLEASE HELP!!
Brian1
February 20th, 2011, 04:32 AM
Are you Full Flashing the DSP2 tune or just doing a Calibration Flash?
Brian
Juniordiesel
February 20th, 2011, 12:46 PM
I was doing a full flash of the ECM. I got it working. After licensing the cable I thought I had shut down the program but hadn't. Everything flashed and the truck runs great. Now having problems figuring out if my switch works or not.
Dmaxink
February 20th, 2011, 12:48 PM
Enable the pid for dsp2 to make sure it is switching voltages.
Juniordiesel
February 20th, 2011, 12:51 PM
I did and when I go to the "data" tab it changes to saying "yes" to saying "no" at different times. What tab do I see the voltage at?
Dmaxink
February 21st, 2011, 09:03 AM
scantool>pids>system>diesel and just scroll down..look for the units next to the pid that says "V" for Volts
Juniordiesel
February 21st, 2011, 12:51 PM
Nope, don't have the PID that says "DSP2 switch voltage." I have them for the DSP5 but not the two.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.