View Full Version : Please Help Two yellow flashing lights
mike8890
February 27th, 2011, 07:33 AM
Please help i installed the newest update and my flashscan v2 started flashing two yellow lights and it hasnt stopped. Now everytime i plug it in it just flashes. How do you fix this. Thanks
Taz
February 27th, 2011, 07:57 AM
Hello Mike,
Sounds like the V2 is in “dead poll mode” (i.e. under Bootblock control). Try updating / programming the Firmware into the V2 - using EFILive Explorer.
In EFILive Explorer - F12 is the Firmware tab - make sure the “Bootblock” box does NOT have a check mark in it.
Regards,
Taz
Tordne
February 27th, 2011, 07:59 AM
The flashing lights indicate that the device is in deadpoll mode. This typically occurs when you have performed a bootblock update and the device does not have valid firmware installed. Please see these knowledgebase articles relating to software and firmware updates:
- Software
(http://support.efilive.com/kb_article.php?ref=5404-IJZV-0820)- Firmware (http://support.efilive.com/kb_article.php?ref=7243-SFGL-2949)
mike8890
February 27th, 2011, 08:06 AM
thank you very much it is working great again
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.