Lml / lgh [Archive] - EFILive Forum

shay

March 10th, 2011, 07:33 AM

Is there any hope to support LML/LGH???????:angel_innocent::angel_innocent:

Thanks
shay

Tordne

March 10th, 2011, 07:56 AM

The short answer is "no". It has been covered at length in THIS THREAD (http://forum.efilive.com/showthread.php?13812-Info-on-New-LML-engines-for-2011).

Basically the LML ECM has been secured and is not able to be read out. Without the read capability it is obviously not possible to obtain a calibration that can be modified and flashed back.

Biodiesel66

March 10th, 2011, 01:41 PM

The short answer is "no". It has been covered at length in THIS THREAD (http://forum.efilive.com/showthread.php?13812-Info-on-New-LML-engines-for-2011).

Basically the LML ECM has been secured and is not able to be read out. Without the read capability it is obviously not possible to obtain a calibration that can be modified and flashed back.

How about LML/LGH BBL and Diagnostic using EFILive Scan? It's setup now, just needs some of the bugs worked out with the PIDs in BBL. Most of the PIDs work using V7.5 using pass-through.

Be a shame to see this go down the crapper toooo!