Full flash after fixing OOR cells?

[gregrob]

Ok guys I uploaded the custom OS per the instructions.

I'm using 0202005 which is compatible with the 02 calibration.

The deal is, the window still says "the following cells were OOR when loaded". I have triple checked that every cell is within the EFI Live min / max values, and set the way I want them.

Also, we grounded pin 56 on a switch and it did NOTHING when activated. We also triple checked the wiring, and even grounded it directly to the negative terminal just above the battery and it did nothing.

I am guessing it could be not working because it still shows that some cells are OOR.

Thanks for any help on this. I'll upload the tune as soon as it will let me

[gregrob]

Here is a copy of the tune.

forddieselpower.com/grfiles/shaw_customos_N20_ONLY.tun

thank you

[joecar]

See here:

Fixing Out Of Range (OOR) Cells:
showpost.php?p=87052 (http://forum.efilive.com/showpost.php?p=87052&postcount=14) post #14
showthread.php?14119-3000-RPM-max-and-setting-codes-03-Z06-with-Magnuson-at-150kPa (http://forum.efilive.com/showthread.php?14119-3000-RPM-max-and-setting-codes-03-Z06-with-Magnuson-at-150kPa) posts #14, #17
showthread.php?14654-I-need-help-getting-the-most-out-of-my-car (http://forum.efilive.com/showthread.php?14654-I-need-help-getting-the-most-out-of-my-car) post#2

[gregrob]

See here:

Thank you Joecar. I will do the change save exit change back save exit reopen routine andpost back!