aem wideband and efilve v1

[badls1]

hey i trying to hook up my aem wideband to my efilive v1. right now i have it wired into the 0-5 volt from the wideband to the 0-5 port on the efilive. is this how i want to run it? i have been hearing that you want to run the serial wire from the wideband to the efilive, is that how i should do it instead?

[joecar]

hi badls1,

V1 only has analog inputs, it does not have a serial input.

[ScarabEpic22]

What Joe is saying is to use a serial WBO2 connection you need a FlashScan V2. :)

[badls1]

okay. so did i wire it correctly then, if i run the analog wire and a ground to the port on the side of my v1? will it be accurate doing it this way or not?

[joecar]

Yes, correct, signal wire to pin C or E and ground wire to pin D on the side port on V1.

You may have to make a calc pid for it, the AEM user manual should show you the voltage:AFR relationship (if it is the same as some other wideband then you can use that wideband's calc pid).

[badls1]

alright thanks for the info. i think its the same as the plx wideband