Chevy366
June 23rd, 2011, 05:39 AM
Went to flash a tune through BBx and got $0502 error code , do what ? Have latest firmware and software , so I cleared "config" and formatted V2 internal memory , went to S&T chose what I wanted , "saved" , then "programmed" , still $0502 , noticed "config" file looked funny (not enough entries) , tried again same thing , finally I cleared "config" , found the config entries for the controller , by clicking "home" , I was using , highlighted , drag and drop into config section , poof , no $0502 .
I thought S&T was suppose to handle the "config" and PCM parameters , did I miss something in this update , noticed some new file extensions .
Note I did select the PCM type in S&T before saving and programming .
No big deal , just curious what is going on with the S&T .
Been messing with Motorcycle to much lost track here . :doh2:
I thought S&T was suppose to handle the "config" and PCM parameters , did I miss something in this update , noticed some new file extensions .
Note I did select the PCM type in S&T before saving and programming .
No big deal , just curious what is going on with the S&T .
Been messing with Motorcycle to much lost track here . :doh2: