PDA

View Full Version : lost pids


hecatti
July 27th, 2011, 03:03 AM
Hello everyone!

I have an issue after updating efi (version170).
In scantool where you choose pids , there is no longer pids for syl.balance rates, act. and des.rail press , inj. timing , dsp5 switch , nothing what you need to log LB7 or diesel
there is pids for fuel rail ,and difference between actual and desired fuel press but it´s not supported
I have been saved a pid list ,but when I open it nothing happened.
First I couldnt do anything before updating firmware which is now 2.07.14 and bootblock 2.07.02
now I´m totally lost , plesae help!!

sorry for the bad language
joecar
July 27th, 2011, 03:28 AM
Hi hecatti welcome to the forum...


you may need to reinstall V7 and V8 manually.
joecar
July 27th, 2011, 03:29 AM
Also see this: Pre-Release-Update-July-27-2011 (http://forum.efilive.com/showthread.php?16919-Pre-Release-Update-July-27-2011)
hecatti
July 27th, 2011, 04:04 AM
thank you and thank you!!!!!!
that fixed my problem:cheers:
hecatti
July 27th, 2011, 10:22 PM
hello again!
now I have problem with flashing, when I check status it says:
The Flashcan/Autocal firmware is not compatible with installed EfiLive software , please update the efilive software on your pc or laptop to the latest version and update the flashcan/autocal firmware that is
distributed with the efilive v8 software , the latest efilive v7.5 and v8 software may be downloaded from efilive.com

I tried several times but still no luck , is it possible continue and make the flash even if status is not ok?

thank you already!!
joecar
July 28th, 2011, 01:36 AM
What V7 and V8 build versions are you at (post screenshots)...?

What V2 bootblock and firmware versions are you at (use EFILive Explorer; post screenshots)...?


The software/firmware versions must be compatible otherwise flashing will fail and the PCM/ECM will be bricked.
hecatti
July 28th, 2011, 02:00 AM
well, I don´t know how to post screenshot, but my V7 is version 173 and V8 162
V2 bootblock 2.07.02 and firmware is 2.07.14
joecar
July 28th, 2011, 02:15 AM
Ok, use EFILive Exporer (goto Firmware tab) and do this (in this order):
- update V2 bootblock to 2.07.03 (checkmark Bootblock checkbox),
- update V2 firmware to 2.07.16 (un-checmark Bootblock checkbox).



Screenshots: see posts #2 and #3 here: Hosting-an-Image (http://forum.efilive.com/showthread.php?3064-Hosting-an-Image)
hecatti
July 28th, 2011, 05:15 AM
thank you for advice , I´l do that next and try again
hecatti
July 29th, 2011, 04:34 AM
hello
Finally I got everything up to date , it seems that new version was released again since yesterday and I was little lost (again) , but now everything looks good.
thanks Joecar!:cheers: