Closed Loop Filter- Tuning w/o WBo2

[Crunkmaro]

Hey,

so i made a few logs,

and can't seem to get any results on map A...

I apply the calc.vet filter
i see results. numbers, that look somewhat real!

i apply the closed loop filter (set up per tutorial) and everything turns to zero.

I thought the car should always be in closed loop once it reaches operating temperature?

I noticed that my calc-factor for CL is 1...does 1 mean its in open loop?

i attached my current tune

as well as my three logs.


i'll figure it out! but would appreciate any advice lol

11554

11555

11556

11557

[joecar]

Yes, CL = 1 means closed loop. Post some screenshots of before/after filtering (show the whole scantool window).

I'm out of town this week so I can't view your files.

[Crunkmaro]

i will do that tonight joecar. thank you!

the calc.vet tutorial says for nb02 tuning, use a closed loop filter which seems to show that i should INCLUDE DATA FRAMES for parameter (O) CLOSED LOOP (based on EQIVRATIO) (factor) and i set the filter type to "equal to" 0 factor

which means calc.cl is equal to 0.

so if closed loop is when calc.cl is equal to 1, then why would i want to only include the data where calc.cl is 0.


i shall post up tonight.

[Crunkmaro]

posting screenshots in "my quest to tune" thread...

[joecar]

CL=0 means not closed loop
CL=1 means closed loop

So you want to include frames for which CL=1.

Oh, including frames for CL=0 would be a typo in the tutorial, Shawn and I were making some changes, I'll fix it.