No timing tables in Calibration

[chrleb2]

I pulled a stock tune out of a truck and was going to tune it. When I went into the main timing, there was not any main base tables. I haven't looked over the rest of the tune though. I'm attaching a copy of it so you guys can check it out.

Thanx,
Erick

[06redram]

I looked at you file, you are missing alot of tables. I am pretty sure EFI tech will chime in

[comnrailpwr]

Truck may have had a box tuner on it at one time and some tables were not returned to the truck. I have nothing to back this up. Just a possibility maybe?!?!

Spray & Pray

[skneeland]

have you tried finding the appropriate "stock" tune from the tune repository and reflashing with that? should be able to build from that base

[Dmaxink]

Efi will correct this for you i'm sure bud. Thanks for the post, this is the only way problems can be acknowledged and corrected.. You can get a stock file for this truck from compd or tunefiledepot... just make sure it is a 48RE. just make sure you put the correct vin in whatever stock file you pull with the scan tool while the truck is connected.

[chrleb2]

I had another Calibration that worked with the truck. I ended up using it and swapped VINs in the program. Just wanted to bring it up so that EFI could see this calibration. Probably and odd one from Dodge.

[djsdiesel]

I had the same issue, havent had time to post it up. I ended up loading a programmer on it then taking it back out. It updated the OS and the tables were there with the updated OS. I have attached the original OS. The AM is the original stock tune, the AS is the updated.

1166911668

on edit just looked at OP's file, its the same one

[GMPX]

Hey guys, yes that OS is a really early one, I know there is some tables missing in it compared to all others but for the most part it should be pretty complete.
I can take another look, but, the easy (and probably better answer) is to update the ECM to a later OS.