PDA

View Full Version : Reduced Engine Power help please



JUSTASBC
August 25th, 2011, 12:58 PM
I have a Magnacharged 05 Silverado 5.3l it has a 90mm T-body with an X-Link water/meth injection, heads, cam headers, dual 3 exhaust. I am running a semi OLSD COS3 with a 2 bar MAP sensor. I had a 2.9 pulley on it for a while, and it would go into REP mode a few times a night at the strip. It never went in until I was just crossing the traps so I just cleared it and went on with my night. I would get a P0102, P1516, and sometimes a P0106 code with it. I recently changed to a 2.6 pulley, and have been going into REP with a P0102, and a P2101 if I hold it at about 60-70% throttle. If I floor it, it will rev up, and often times go into REP with a P1516 and P0102 code. I have done a resistance check on the wires to the Tbody, and they check OK. I have also checked the ground wire to the passenger side head, and that appears to be fine.

joecar
August 25th, 2011, 02:22 PM
I think you are exceeding the TPS, ETC or MAP rationality tables (look in the Engine Diagnostics folder).

Are you running a MAF...?

JUSTASBC
August 25th, 2011, 02:49 PM
No MAF. Well it is in the inlet after the filter, but it is unplugged. I am running my IAT sensor where Magnacharger puts it in the intake.

driver456
August 25th, 2011, 11:55 PM
The P1516 code is whats causing REP.You are supposed to get the P0102 when you have the MAF disconnected,SD mode.Check the wires going into the TPS................Paul