Another lc-1 and taq cable thread..

[endlink]

So I followed the tutorial to the T and I'm not getting the led 2 from the left (communication) light blinking. My WB gauge works but for some reason I cannot log the wbo2 pids because I have no communication. My software is up to date. Any suggestions?
- Ed

[endlink]

I did notice my flashscan v2 doesnt have "com in" and "com out" settings. It only has "com port" which i changed to "wide-O2".

[joecar]

Which V2 firmware does your V2 have...?

[endlink]

bootblock version 2.07.03 firmware version 2.07.22

[joecar]

Did you set wideband type to Innovate...?


Do you have a null modem cable (from TAQuickness)...?

[ScarabEpic22]

Make sure you have the null plug inserted into the proper port on your Innovate cable. Im pretty sure it goes into the Com In and the Com Out goes to your V2.

[joecar]

+1 what Erik said...

the blank stereo plug that comes with the LC-1 is a terminator, this has to be plugged into the LC-1's SERIAL IN.

[Quickfix]

So, did it work for you?

I have the same Problem.

I did notice my flashscan v2 doesnt have "com in" and "com out" settings. It only has "com port" which i changed to "wide-O2".

[T&A Custom Rides]

ttt same problem

[joecar]

V2 has a setting for selecting the comms direction (dyno or wideband) and the brand of wideband (e.g. Innovate).

Also look at post #7.