View Full Version : 98 to 99 Fuel Segment swap gauge output table
AutomagicLS1
September 27th, 2011, 06:57 AM
I've done a fuel segment swap to run a 99+ PCM in my car. I am trying to get the fuel gauge to work. Question though what are you guys using in the Gauge Output vs Level table and Primary Volume vs Level table? You guys using the 98 table? 99+ table? The express van table? Stumped here
Taz
September 27th, 2011, 07:37 AM
There are more than a few threads on upgrading from an LS1-A PCM to and LS1-B PCM. Perhaps try a search of the Forum ... probably what you need is already here.
Below is one of the threads I found using the search function ...
http://forum.efilive.com/showthread.php?7060-98-to-99-pcm-swap-question-please-help&highlight=fuel+gauge
Regards,
Taz
AutomagicLS1
September 27th, 2011, 07:40 AM
There are more than a few threads on upgrading from an LS1-A PCM to and LS1-B PCM. Perhaps try a search of the Forum ... probably what you need is already here.
Below is one of the threads I found using the search function ...
http://forum.efilive.com/showthread.php?7060-98-to-99-pcm-swap-question-please-help&highlight=fuel+gauge
Regards,
Taz
Actually that information you posted I have already done and isn't even the topic of my post.
Thanks again
Taz
September 27th, 2011, 09:29 AM
The point of my post was to take a look for the material yourself ... often faster than waiting for someone to post up.
You are welcome by the way ...
Regards,
Taz
EDIT: Received your message - only the moderator (Joecar) can lock threads ... I was trying to be helpful ... unfortunate that you seemed to have misinterpreted this ...
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.