cant connect to ecm

[crash85]

I was loading a tune and the battery went dead in the laptop and i charged it and went back to load the tune now it wont connect to the ecm it atttempts 10 time then say it lost connection

[crash85]

any one i need to get the truck back up and running is the ecm fried?

[JustinD]

Just do a full reflash it will tell you its in an unknown state but it should take the full reflash, at least the ones I've done.

[crash85]

ive done it it wont work and ive tried alt keys and nothing is working it just says that it lost connection

[JustinD]

Did you try a FULL REFLASH?? Its under the flash menu, then there are 2 reflash options use the "program pcm operating system and calibration" I think since you disrupted it you'll need a full reflash now?? If not maybe someone will have more info. Good luck man.

[Dmaxink]

for giggles...unplug your batter for a while and try it again...also, is your battery pretty much fully charged now? I have seen the battery have low power and have this issue

[crash85]

thats what ive always have used a full flash

[crash85]

yea every thing is charged up now just tried it and it said the same thing

[crash85]

any ideas?