PDA

View Full Version : Wrong voltage on A/D



norm8332
October 16th, 2011, 03:44 AM
Hello, I just got my Flashscan v2 and I'm trying to connect a analog WB. The problem I'm having is the voltage shows wrong in the external sensor display on the unit. It will not show higher than 1.2 volts. I see a calibrate menu choice but cannot find an explanation. I have upgraded everything to the latest firmware/boot block/software. Any ideas?

Thanks.

Norm

EDIT: Forget it. I found it.

joecar
October 16th, 2011, 12:40 PM
What was the problem...?

norm8332
October 16th, 2011, 01:59 PM
It was my mistake I didn't realize it needed to be connected to the car or other 12V source to read correctly. I somehow missed that in the manual. All is good now.