Problems with Cable.

[jamesbond2509]

Recently I have been programming often with my flashcan V1. Just today I started getting the error code no_cable/31 when I try to connect. When I plug the usb, the computer acknowledges the USB with the tinkle sound but I cannot connect to either the scanning or tuning software. On the cable the green and yellow lights are flashing. Help Please!

[joecar]

Hi JB,

Did you recently update your software...?

[Tordne]

Do you see the device appear, and shown as a FlashScan FSP, in Device Manager?

[jamesbond2509]

No I did not recently update my software - everything was working fine then all of a sudden the software does not recognize the cable on both the scan and tune - I have to tune the idling for a new throttle body so Im desperate.

[jamesbond2509]

I think it reads it as some kind of usb device but not efilive anymore. I'll have to check again tomorrow as the cable is in the car.

[Tordne]

In some rare conditions the USB chip can lose it's configuration. See this article (http://www.efilive.com/index.php?option=com_content&view=article&id=112&Itemid=122) and see if it helps. The MProg application has been replaced with the new FT_Prog application, but it's pretty much the same.

[jamesbond2509]

Ok, I'll check that out tomorrow. Thanks

[jamesbond2509]

I followed your instruction using Mprog and probelm solved - Thanks Again

[Tordne]

Thanks for the update, and glad it worked :)