Isuzu Flat Bed Truck with E38 and 6.0L

[frcfed347]

Hey guys,

Is there any support at the time for this? I recently tried to read the PCM, and it won't read yet, but I was wondering if there is a possible update for it. It's very similar to some of the GM trucks and vans. Thank you.

[Taz]

Hello Frcfed347,

What model year is the truck ? What service number is affixed to the back of the E38 ECM ? What transmission is it using ?


Regards,
Taz

[frcfed347]

I believe the OS ID is 12644905. The trans is the Allison based 6 speed HD for gas vehicles. Let me know if this helps. Thank you Taz.

[Taz]

Don't have that OS on file. Is the vehicle a 2011 or 2012 model ? If so, it may be an E78 ECM.


Regards,
Taz

[ScarabEpic22]

Going with Taz, what year is the truck? Make sure your V2 is fully up to date with the latest firmware and V8 software. Also try reading it with V8, Open V8 S&T then click F3 Tune. Should default to F2 Read, try clicking Auto Detect to see what EFILive thinks the ECM/TCM are.

[GMPX]

It was an E38 and I hope to have a .calz done for it for the next release.

[frcfed347]

Yes it is an E38. When is the next release? (I won't hold you to an exact date) Thanks.

[GMPX]

Not 'exactly' sure. There is a lot of changes in the next release with file formats, it's been in closed beta for 3 or 4 weeks now. I'll get Andrew to Email you the .calz file directly so you don't have to wait for the update.

[frcfed347]

Thank you so much that would be great. Do you have an email with you user name? If not I can PM you my email address. Thanks again.

Steve

[GMPX]

Send a message to [email protected] with a link to this thread.

Cheers,
Ross

[frcfed347]

Email sent.. Thank you.