PDA

View Full Version : Help all GM pids are disapeared after last update


wesam
November 12th, 2011, 03:15 AM
Help all GM pids are disappeared after update
now gust i have the SAE, calculated and EXT pids in the scan tool but there is no GM pids
Taz
November 12th, 2011, 03:38 AM
The problem may be that the V2 needs to be reprogrammed ...

Take a look at the thread attached below ...

http://forum.efilive.com/showthread.php?16038-problems-with-V2-after-doing-new-update


Regards,
Taz
wesam
November 12th, 2011, 04:43 AM
The problem is not in the V2 the problem is that the scan tool is not showing the GM.xxx PIDs ( i mean all GM PIDs are not there, not that they are not supported )
I already reprogrammed the V2 but still have the same problem
wesam
November 12th, 2011, 12:38 PM
Any help ??
ScarabEpic22
November 12th, 2011, 12:47 PM
Open the Scan Tool, Edit->Validate PIDs.
wesam
November 12th, 2011, 12:51 PM
i think you mean info -> validate PIDs
its not active
i can't select it because its hidden
Whippled 496
November 13th, 2011, 02:29 AM
I am having the same issue after the update.
wesam
November 13th, 2011, 02:53 AM
Any body ?!!!
Taz
November 13th, 2011, 04:47 AM
... all GM pids are disappeared after update ...

Were these updates done via the "Check for Updates" feature of your software, or were these downloaded directly from the EFILive main website ?

The "Check for Updates" feature has not been working properly for sometime now.

Just a possible cause ...


Regards,
Taz
wesam
November 13th, 2011, 05:08 AM
It was done via check for updates
i will try to install the update directly from the web site
ScarabEpic22
November 13th, 2011, 01:29 PM
Check from updates hasnt worked in a few months, DO NOT USE IT until EFILive says its working again. Weird things like this are happening if you use it.

And yes it is Info->...was going off memory ha.
joecar
November 14th, 2011, 12:41 AM
Manually install V7 build 180 and V8 build 170 (like Erik said).

Flash firmware 2.7.22 into V2.
wesam
November 14th, 2011, 07:08 AM
Ok the manual installation fix the problem
but now the EOP PSI is not working its giving zero value all the time not like before :(
Thanks a lot
joecar
November 14th, 2011, 12:08 PM
Which version did you update from...?
joecar
November 14th, 2011, 12:09 PM
The EOP pid only works for Corvettes.
wesam
November 14th, 2011, 06:36 PM
I did not check before updating :(
wesam
November 14th, 2011, 06:36 PM
The EOP pid only works for Corvettes.
It was working before update
joecar
November 15th, 2011, 02:11 PM
Try entering a Corvette VIN.
DrkPhx
November 20th, 2011, 10:54 AM
FYI- I have the same exact problem and downloaded the new version directly from the website.
DrkPhx
November 24th, 2011, 06:30 AM
Update. I fixed the problem by uninstalling 7.5 and reinstalled it which fixed the issue. Move along.