V2 Com Port settings and firmware updates.

[Quickfix]

Hi,

i am a newbie on the forum, but i have done my best to research before posting. i have recently updated my V2 flashscan firmware and boot blocker. i followed the tutorial but i am not sure if i have made mistake. i have the latest 2.07.22 firmware and 2.07.03 boot blocker. my problem is this:

After trying to follow the serial wideband tutorial, i noticed that they require change Com-port in and Com port Out, and i only have one Com port setting (no com port in and out as per tutorial).

my question is: am i on the right track or have i missed something with my firmware update.

i think i could have skipped a step with the firmware update. and should have to reset my firmware somehow and start all over .

can some help please.

Your help is appreciated.

[ScarabEpic22]

No, if its an Innovate then ignore their documentation on this. Make sure the null adapter is plugged into the COM IN port on your WB controller, then connect a cable between the COM OUT and your V2. Set the WB controller to be the correct manufacturer and program your V2. Should be good to go. It confused me a little at first, but then I realized the COM IN is for programming the controller or daisy-chaining multiple together.

[joecar]

Set your V2 as shown:

12329