02greysixer
November 26th, 2011, 08:01 AM
I will be buying a v2 in the next week or 2 and I have a question. I have a 2002 Lb7 Duramax with a slight of smoke at start up and right off idle. My truck isn't seeing/reading the barometric pressure sensor. It sees and reads the map but not the baro. I've tested all 3 wires on the baro plug, everything checked out ok. When I read what little bit I can with my diablo I get a reading of 14.3 intake manifold psi and 2psi boost with engine off key on. If I unplug the map the boost goes to 0 and the manifold pressure goes to 7.3, however if I unplug the baro nothing changes. I've replaced both baro and map, still no change. My question is, with the efilive tuning and v2 is there a way to delete or set the baro to "0"? And by 0 I mean at or slightly above sea level. I live in Fl so changes in elevation don't happen.
Sorry for the long read, hopefully someone can help! Thanks.
Sint frum tha orijinul smert fone
Sorry for the long read, hopefully someone can help! Thanks.
Sint frum tha orijinul smert fone