Selben Map?

[Bill00Form]

I've setup this MAP as instructed by the new twist on tuning thread (at least I tried to) and have a question. Car was idling and reving up to maybe up to 2,000 rpm(max) but the cells in the selbern map in the 3,500 to 4,500 rpm range were being filled in. Does anyone know what would be causing this. Also, since the selbern map is for MAF tuning, I thought most tuning for MAF was done at WOT. Is that not the case? Thanks

[Bill00Form]

I thought it was rpm but maybe it's MAF Frequency (hz). The table is a little confusing in that you enter rpm as one of the axis.

[joecar]

In the map properties check the Empty tab; also check the filter, it might be excluding idle data.

single-width map column:
you can use any pid that you have logged, and you make map range equal to the full range of the pid, this causes this single column to always be active;
so for example at some rpm (x) and Hz (y), the map cell is located by (x,y);
post some screenshots.