Timing, Boost Adjust D6270

[FUBAR]

Looking at this table, I don't know how this would be dependent on boost other than the fact that it's setup in low-mid mm3's where boost would not be at peak. I also say that because the axis's are mm3 and rpm, no where is there boost factored in the table. Also, if this table works, my timing should be super retarded (low.) Somebody maybe can shed some light?

Thanks,

[skneeland]

that table used in conjunction with D6273 (it has the boost reference on it). most of table D6270s values would be zeroed out as a result of D6273 modifiers except for a few conditions with less than atmospheric pressure (clogged air filter anyone? lol )