Sledhead
February 13th, 2012, 01:33 PM
I downloaded the current builds today onto a new laptop with hopes of installing a new tune. I updated both V7.5.7 and V8.2.1 successfully and then updated the firmware on my V2 successfully. Bootblocker didn't need updating.
I pulled the radio, info and radio amp fuses. I successfully read the DSP5 tune currently in the truck and saved it. I then did a full flash TEST which went through the whole routine and reported success. Truck started fine. Then I tried doing a full flash for real but got an error message; Cannot Erase the ECM Memory, Reason: (blank). I got the bad Transfer was stopped, do not remove power message.
Good news: truck still runs. Bad News: I can't get my new (Single, Non DSP tune flashed in) Perhaps it is a discrepancy with OS?
I will email the transcript and trace file to support.
Here is the transcript. 12681
I pulled the radio, info and radio amp fuses. I successfully read the DSP5 tune currently in the truck and saved it. I then did a full flash TEST which went through the whole routine and reported success. Truck started fine. Then I tried doing a full flash for real but got an error message; Cannot Erase the ECM Memory, Reason: (blank). I got the bad Transfer was stopped, do not remove power message.
Good news: truck still runs. Bad News: I can't get my new (Single, Non DSP tune flashed in) Perhaps it is a discrepancy with OS?
I will email the transcript and trace file to support.
Here is the transcript. 12681