lc-1 wideband serial - AFR MAP

[Bill00Form]

I am trying trying to setup an AFR versus RPM map. In the map properties, there is a "wideband AFR 1 LC-1 - not currently selected" under parameters. Is that the one I select? Thanks

[joecar]

Hi Bill,

if your LC-1 is connected to your V2/V1 using analog voltage, then yes CALC.AFR_LC11 is the right one;

if your LC-1 is connected to your V2 using serial comms, then no that's the wrong one; the right one is EXT.WO2AFR1;


you can setup your V2 to automatically log EXT.WO2AFR1.

[joecar]

From your log files I remember that you have a V2, so you would use EXT.WO2AFR1.