PDA

View Full Version : Help a newbie please



K80
March 23rd, 2012, 08:12 AM
I just received my EFI Live setup and installed on my laptop. I'm assuming I data log the tune that's in there first and then work from there (tune is from Shane at PDW). So what now? Is there a link so something for complete newbs for how to log for the first time?

K80
March 23rd, 2012, 01:03 PM
Do I have to download the most recent release candidate? Can I just plug it into the truck and log?

Ira
March 23rd, 2012, 01:59 PM
Open up the V7.5 scan tool. Then go to Help => Tutorials => Scan Tool Tutorial and work through all the steps there.

Ira

K80
March 23rd, 2012, 02:29 PM
Thanks Ira.

chance cobb
March 24th, 2012, 02:50 AM
one the first page of this forum there a place you can get the most resent update

chance cobb
March 24th, 2012, 02:51 AM
one the first page of this forum there a place you can get the most resent updatehttp://forum.efilive.com/showthread.php?18780-Release-Candidate-10-(updated)-Mar-21-2012

K80
March 24th, 2012, 07:56 AM
Ok. I tried connecting with the V7.5 scan tool and it didn't work. Error said to download V8. So I did. Now I'm just going through Ira's tutorial. I did download RC10 too. Thanks Chance.

K80
March 24th, 2012, 10:55 AM
I have a HUGE problem now (I think). It is almost stuck in the middle of flashing. I'l see if I can get a screenshot but after 23 minutes of flashing i figured there was a problem. There is 4:36 left to be flashed. Now I can't exit the software, it's not timing out and the truck is all screwed up. PLEASE HELP.

K80
March 24th, 2012, 11:10 AM
http://i1105.photobucket.com/albums/h341/KXTRAP43/screenshot.jpg

chance cobb
March 24th, 2012, 12:53 PM
never seen that before

chance cobb
March 24th, 2012, 12:58 PM
only thing i could ask is was the tune right for your truck as in the vin number and everything else ?

K80
March 24th, 2012, 02:41 PM
After a couple hours of pulling my hair out it closed and I reflashed. So at least I have a running truck right now lol. But when connecting to the scan tool V7.5 an error comes up that I have to update firmware to V8. I've been searching but the only thing that I can come up with updating firmware on the flashscan tool. Sorry for all of these dumb q's and problems.

cmcz450
March 24th, 2012, 05:09 PM
well update the flashscan firmware **all programs--v8--explorer tool--update firmware. It'll need done if you haven't. Are you sure you have the latest RC10? March 21
http://forum.efilive.com/showthread.php?18780-Release-Candidate-10-%28updated%29-Mar-21-2012