WicketMike
February 5th, 2006, 02:47 PM
I was going to do my AutoVE on the Gold T/A since i got the STS Turbo installed this weekend but the damn LC1 sensor isnt working so i had to plug the MAF back in and try to watch the LTFTs for now.
When i was scanning it, the P0103 code came on, the bank 1 sensor 1 looks like it died. When the code came on, the left side was just reading "0".
i got a few questions.
1. What does the pcm fall back onto now that the Narrowband 02 sensor has died? If it was running lean, will it now not make up for it?
2. What can make that narrowband 02 sensor go bad? It went out when i went WOT.
3. On my LC-1, it reads 14.7-14.9 in flashscan and 24.7-24.9 on my pillar guage and never any other numbers. So the wideband 02 sensor isnt working, any ideas here?
thanks
Mike
When i was scanning it, the P0103 code came on, the bank 1 sensor 1 looks like it died. When the code came on, the left side was just reading "0".
i got a few questions.
1. What does the pcm fall back onto now that the Narrowband 02 sensor has died? If it was running lean, will it now not make up for it?
2. What can make that narrowband 02 sensor go bad? It went out when i went WOT.
3. On my LC-1, it reads 14.7-14.9 in flashscan and 24.7-24.9 on my pillar guage and never any other numbers. So the wideband 02 sensor isnt working, any ideas here?
thanks
Mike