TJWells
April 26th, 2012, 01:53 PM
I have an 06 z06, I purchased a used set of headers and hi flow cats from a friend. The x-pipe came with the original 08 z06 rear o2's
installed. The problem is they are a different part number, and I believe they have a different resistance on the heater circuit. almost immediately
when the car is started the check engine light comes on with a p0054 and a p0060. If i set these to no mil will the monitor still run and clear?
I will change the sensors if i have to but i know these sensors have very low miles on them (less than 3k), and the original installer did not fasten the
harness extensions so they melted to the 02 sensor connectors. these sensors functioned perfectly in the 08. I'm just not sure what needs to happen to set the readiness monitors.(other than drive cycle)
Thanx in advance.
installed. The problem is they are a different part number, and I believe they have a different resistance on the heater circuit. almost immediately
when the car is started the check engine light comes on with a p0054 and a p0060. If i set these to no mil will the monitor still run and clear?
I will change the sensors if i have to but i know these sensors have very low miles on them (less than 3k), and the original installer did not fasten the
harness extensions so they melted to the 02 sensor connectors. these sensors functioned perfectly in the 08. I'm just not sure what needs to happen to set the readiness monitors.(other than drive cycle)
Thanx in advance.