PRAY
May 22nd, 2012, 10:45 PM
What is the max value I can enter into this table. I maxxed it out and the truck wouldn't go any where when I hit the throttle. I remember on my GenIII ECM in my 06' Silverado that a similar table to this I had to 0 which is the opposite direction of logic. Is this table the same. I have deleated the rest of the ECM TQ Man and this is the last table that could be causing me problems. Basically when I hit the gas from a stop or roll there is a flat spot in the lower rpms where nothing happens and timing is pulled at random spots. Then it goes away the the truck moves out. Also, how do Newton Meters compare to Foot Pounds when comparing torque calculations? Vehicle is a 07' TBSS. Thanks.