View Full Version : Instructions for capturing the stock file
sardawg1
May 27th, 2012, 03:17 AM
I can't find any instructions on how to capture the stock file, can some one point me in the right direction please.
Thanks,
Tom
GMPX
May 27th, 2012, 10:06 AM
Have a read through the pdf shown below.
http://download.efilive.com/Staff/GMPX/CumminsQS.png
DoghouseDiesel
May 27th, 2012, 01:37 PM
He's good. Talked him through it earlier today.
He has a bad USB cable. Swapped it out and it worked fine.
sardawg1
May 28th, 2012, 09:36 AM
He's good. Talked him through it earlier today.
He has a bad USB cable. Swapped it out and it worked fine.
Thanks for the help Rich. I am trying to get some data logs for you but i'm still having issues with the program freezing and becoming non-responsive.
DoghouseDiesel
May 28th, 2012, 04:09 PM
Thanks for the help Rich. I am trying to get some data logs for you but i'm still having issues with the program freezing and becoming non-responsive.
You're not the only one. This has been mentioned several times.
Initially, I had said something about this after a dyno session and thought that it may have been an EMI issue with the Eddy brake. The only time it was doing it was with the laptop outside the truck and on the table.
Bu, since then, even with software updates, I've still had the freezing / temp stoppage issues.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.