Cruze trans. file Out of Range values - WACKY?

[Boost]

Working on T76 Operating System 24261415. There are some out of range values in multiple shift tables, single cells that are red spikes and way out of wack. When I try to fix them the whole table changes automatically and gets messed up. Could not upload the file here yet but these are the ones:

Transmission Calibration.Shift Times.1->2 Desired Shift Times
{D9006} 1->2 Desired Shift Time Input Torque Mod (Pattern A), contained one or more out of range values when loaded.

Transmission Calibration.Shift Times.3->4 Desired Shift Times
{D9066} 3->4 Desired Shift Time Input Torque Mod (Pattern A), contained one or more out of range values when loaded.
{D9067} 3->4 Desired Shift Time Input Torque Mod (Pattern B), contained one or more out of range values when loaded.

Transmission Calibration.Shift Times.4->5 Desired Shift Times
{D9087} 4->5 Desired Shift Time Input Torque Mod (Pattern B), contained one or more out of range values when loaded.

Transmission Calibration.Shift Times.5->6 Desired Shift Times
{D9108} 5->6 Desired Shift Time Input Torque Mod (Pattern B), contained one or more out of range values when loaded.

Any ideas?

[Boost]

Before: 13355
After: 13356

[GMPX]

You must have something funny going on there, they don't like that here.
I wouldn't recommend flashing that tune in, who knows what it's really looking at (or changing) there.
Try using the attached .calz instead. Save it in to:
\Program Files\EFILive\V7.5\Calibrations\T76

[Boost]

That fixed it Ross! THANKS!!!

[joecar]

Will that calz be included in the next build version...?

[GMPX]

I think Roland may have been sent a very early .calz with some 'in progress' tables shown, or, he's .calz file was corrupted.
I'll have to check with Paul what versions in are the latest build, I'm sure it won't be the one Roland had.

[Boost]

Possible. In any case it works great now thank you! I have not noticed anyone else with that issue.

[modpcm]

Hi, Is the T76 tuning for the cruze only available for beta tester ? my OP/Sys is 24260286

thanks

modpcm

[GMPX]

I must admit I thought I had told Paul to build the latest release with the T76 .calz files, but it appears I may not have :doh:
I'll make sure they are in the next update, which I am sure won't be too far off.