gpr
July 9th, 2012, 08:35 PM
I'm finally getting around to install the LC1 on my car. The tutorial shows to hook the yellow and ground to efi live, but this is for v1. Is it connected the same way on the v2? all i need is to put the yellow wire (analog 1 output) from the lc1 and also the ground wire, and then i put both into the orange connectors, and that goes into the 0-5 volt ports on the v2. Is this correct?
I thought i read somewhere you could use the serial out of the lc1 instead and then plug the serial cable directly into the v2, is that correct? if so it would be much easier. Also what do i need to do on the v2 to get it reading a/f if i use the serial cable? I have programed lc1's before for the analog outputs, can you program the serial output on the lc1 as well?
thanks for the help.
I thought i read somewhere you could use the serial out of the lc1 instead and then plug the serial cable directly into the v2, is that correct? if so it would be much easier. Also what do i need to do on the v2 to get it reading a/f if i use the serial cable? I have programed lc1's before for the analog outputs, can you program the serial output on the lc1 as well?
thanks for the help.