jmac
August 2nd, 2012, 03:54 PM
I was tuning(attempting) a buddy's truck. 02 chevy.(15186006 OS)I was using a proven script from a reputable tuner on here.I have used it many times with no Issues.Its a dsp 5 tune
Everything went just like it was supposed to.I did the full flash,everything went just like normal.When it was done I noticed a clicking.Turned key off waited the 15 secs,turned the key on and the clicking was still there.After a search the clicking was coming from the ign circut breaker,and the glowplug relay and possible 1 other thing in or around the lifter valley.Anyway it crankes but no start.When I try to go back in it says it cannot connect to ecm.Same with the scan tool,it can't hook up.But if you use the test feature before flashing it says its good.But after a few secs it comes up that it lost communication.I'm out of ideas.I disconnected the battery's for 20 min,then retried with no change.Its setting with them disconnected now.
Here is the stock tune.The stock tune after converted to dsp5.I can email or pm the script file,or tuned dsp5 if need be.What can be done to get this going again?
It had a banks setup with speedloader on before(if it matters)But was removed correctly.It also has the ppe high idle switch.(if that matters)
Everything went just like it was supposed to.I did the full flash,everything went just like normal.When it was done I noticed a clicking.Turned key off waited the 15 secs,turned the key on and the clicking was still there.After a search the clicking was coming from the ign circut breaker,and the glowplug relay and possible 1 other thing in or around the lifter valley.Anyway it crankes but no start.When I try to go back in it says it cannot connect to ecm.Same with the scan tool,it can't hook up.But if you use the test feature before flashing it says its good.But after a few secs it comes up that it lost communication.I'm out of ideas.I disconnected the battery's for 20 min,then retried with no change.Its setting with them disconnected now.
Here is the stock tune.The stock tune after converted to dsp5.I can email or pm the script file,or tuned dsp5 if need be.What can be done to get this going again?
It had a banks setup with speedloader on before(if it matters)But was removed correctly.It also has the ppe high idle switch.(if that matters)