View Full Version : Trying to tune VE and goes lean after copy and multiply with labels....help
lstruck
September 9th, 2012, 10:36 AM
Okay I must have set something up wrong again because when I datalog this tune and then copy with labels and then go to past and multiply with labels (and flash it again when I crank the car up it just reads lean? )
Did I set my scan tool up wrong?
138801388113882
something had to of been set up wrong.
joecar
September 10th, 2012, 01:55 AM
Post screenshots of your map and the VE table...
( show units in the map )
Which wideband do you have...?
lstruck
September 10th, 2012, 01:58 AM
sorry, again I had the wb connected wrong and failed to catch it. now only see .8, .9 or 1 in map table instead of .6 and .7. damn this learning curve lol.
joecar
September 10th, 2012, 02:03 AM
In the map properties, on the Data tab set the Precision to 3 or 4 (and remember to Save), and post a screenshot.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.