PDA

View Full Version : 2006 zo6 reduce power



69camaro5speed
September 22nd, 2012, 02:18 AM
Working on a 2006 427 zo6, mods are a fast intake 102 mm throttle body ,headers,big cam car is a hand full to drive (makes good power) but it goes into reduce power and cut throttle to 42%
Any ideas little scarey street testing 100 mpr side ways
It doesnt seem to do it on a rpm sweap just when hitting a couple gears

Boost
September 22nd, 2012, 11:48 AM
Let me drive it LOL and I'll tell ya what I thinks :devil_2:

Any codes?

wesam
September 22nd, 2012, 03:08 PM
You can increase the values in C0806 which affects the tests for MAP and MAF code P0106 and TPS code P0121. If that doesn't work, you can change the values in C0404,C0407 test parameters so the test is active, but for a narrower range.

Redline Motorsports
September 22nd, 2012, 03:44 PM
Post your calibration....your just missing one table....too much to guess at!

69camaro5speed
September 22nd, 2012, 09:33 PM
i did post it all ready

69camaro5speed
September 22nd, 2012, 09:44 PM
yeah did that all ready, maybe I need to do more,what I didn't do was rase 3001,3002,3003 thinking that could be it idk
i did a search on 3001,3002,3003 nothing came up so i know nothing about it

69camaro5speed
September 22nd, 2012, 09:54 PM
yeah map and tps performance not sure that could do it ,I have not had them do it on other cars but this is the first ls7 zo6 I have done
sure would be nice to see the logic behind what happens when codes are thrown but I guess that would cause other problems for efilive

swingtan
September 23rd, 2012, 10:24 AM
List the DTC that was thrown when reduced power mode came in.
Don't log TP%, lof ETCTP, that way you get the correct throttle opening percentage.
You might want to look at {B2517} if you left TC on.
You logged 475gm/Sec at 7100 RPM, which is only just inside your settings for {C0803}
I'm going to assume you were logging via the laptop, as the frame rate seems a little slow.


Taking points 4 and 5, I think you probably exceeded your ETC parameters {C0803} but as the frame rate is low, it doesn't show up in the log. I'd probably bump the whole table by 20% and retest.

Simon.

69camaro5speed
October 6th, 2012, 02:10 AM
ok I will make the changes,I looked at a zr1 tune guess they do some things differant there 280 grams @ 6200 in c0803 I am sure it smokes that, sure would be nice to see the strategy behind the dtc besides waiting untill they are set and then guessing what table that was hit caused it