Defective LED with my LC-1 what to do without it?

[rumblebox]

I got a defective LED with my LC-1, so i put a regular 194 bulb in its place. . I assume it's not enough current to power a regular bulb, because it doesn't do jack shit. I can feel the sensor heating up though. How long does it normally take to warm up and calibrate so i can start using it in the meantime until i can go buy a new LED?

[joecar]

Get a red LED from Radio Shack (show them your defective one).

[rumblebox]

I got an LED today with the right specs in the manual. It goes trough the warmup procedure and stays solid like it should. Now i need to figure out why the narrow band wire isnt working.

[joecar]

How is your LC-1 wired for narrowband...?

Do you have both the LC-1 narrowband signal and return wired to the PCM NBO2 connector...?


see here: Yet-another-LC-1-question (http://forum.efilive.com/showthread.php?639-Yet-another-LC-1-question)

[rumblebox]

i only have the yellow NB wire connected to the PCM NBO2 connector.

i also made this just now. i'm about to set up the maps and PID's to log with the WB... if it works.

http://i17.photobucket.com/albums/b53/rumblebox/DADE66C3-26A0-4A73-B603-7CCB34EB6617-13094-00000BAAD022D633.jpg

[rumblebox]

none of the PID's in the autoVE tutorial are on my V2. so i have absolutely no idea how to do this. this shit is seriously pissing me off. fuck this.

[joecar]

You can view the serial AFR/Lambda on your V2, use the keypad/menu to go down until you see the wideband display.


but first see here: Setting-up-a-FSV2-from-scratch (http://forum.efilive.com/showthread.php?20699-Setting-up-a-FSV2-from-scratch)