PDA

View Full Version : Error $0109 after update?



Phantomx55
October 22nd, 2012, 02:49 PM
I originally tried to program a tune to my car, and was given an error $0600 while programming. I thought the tune might have been corrupt, so I cleared the tunes off my autocal and then put them back on again. I also checked the firmware and it offered me an update which I proceeded with. I received an error during the update, and now my autocal just flashes and gives me error $0109 constantly.

If someone would be able to help me fix this, it would be much appreciated.

joecar
October 23rd, 2012, 04:09 AM
After you updated the firmware did you program all the BBx configuration...?

Phantomx55
October 23rd, 2012, 04:55 AM
Whenever I clicked program it would give me the same error. I left my autocal at home but will try to check it out later.

joecar
October 24th, 2012, 02:46 AM
Did you do this:
- install V7 build 211 and V8 build 203...?
- flash firmware 2.07.35 int your V2...?

Does the V2 LCD show the menu...?

Are the amber LEDs flashing alternately...?