PDA

View Full Version : Ngk wideband


DYNOBOB
November 24th, 2012, 08:28 AM
Are there any tutorials on how i can add my NGK WB to the V2 interface?
joecar
November 25th, 2012, 03:41 PM
Does your NGK have a serial comms output...?
DYNOBOB
November 26th, 2012, 05:27 AM
No, just a 0-5 analog out.
DYNOBOB
November 26th, 2012, 12:14 PM
Anybody. Switching over from hptuners. would like to get my wideband involved. thanks.
joecar
November 26th, 2012, 03:11 PM
See page 104 in the scantool user manual pdf...

now turn your V2 over (so you can see the back of it) and take note of the labels (next to the multi-pin orange socket across the bottom)...

look for A1 and note the polarity (+ and -) of its two pins...

connect as follows (using a 2 pin orange plug):
NGK analog signal to V2 A1+
NGK analog ground to V2 A1-

( note: A1 is sometimes referred to as AD1 )

Then start the scantool, goto the PIDs tab, select these pids:
- EXT.AD1
- CALC.AFR_NGK1
- CALC.BEN_NGK1

select the other PIDs you want to log (for LS1 keep the pid channel count at 24 or less for fastest sample rate)

connect to vehicle and log.
DYNOBOB
November 27th, 2012, 01:10 PM
Ok, I'm on it. Got a little busy today. Man there is some good info in that manual! used to the other tuning software where it was trial and error. thanks.
joecar
November 27th, 2012, 01:24 PM
More info may appear in this section of the forum: Tutorials (http://forum.efilive.com/forumdisplay.php?17-Tutorials)
DYNOBOB
December 12th, 2012, 01:01 PM
Sorry it's been awhile. Got my NGK AFX set up and logging. Also made some custom histograms. really like this compared to the "other guys". Was working with a E38 ecu over the weekend, what a blast!! being able to "click" and have the coeffecients generated is awesome! Also found some E38 tables and settings in the same cal i was working with previously that did not exist in other tuning software.
joecar
December 12th, 2012, 01:31 PM
No worries :cheers:

Cool :cheers: glad you like it.