I can't full flash with W8

[Highlander]

any workarounds? besides going back to w7 or xp.

[ScarabEpic22]

I flashed with W8 no problem using V8, when opening the V7.5 Tune Tool I only get half of the status bar (loading calibrations bar). I didnt try flashing with V7.5 and Ive only flashed a T43 a few times with W8 and V8.

Have you tried running the Scan and Tune tools in compatibility mode for W7?

[joecar]

What are you flashing from (V7, V8, V2)...?

[Highlander]

Both v7 and v8 cable is v2

Yes I have tried all the possible combinations of compatibility modes etc even doing the install itself in compatibility

I have no issues with cal flash though

The program tries to flash and after sending bootloader ot automatically says completed

[joecar]

With serial wideband...?

[Highlander]

Serial wodeband?

[joecar]

Is your wideband connected to your V2 using serial comms or analog voltage...?

[Highlander]

Yes and No... both ways.. connected or disconnected... it will jump to the just finished without going through the prep steps.

[GMPX]

I'm sure that is the old 'non admin' problem, try running EFILive with admin rights (not sure how you do that on Windows 8), but Win 7 was just right click on the icon and choose Run as Admin.