Cant seem to get DFCO to enable

[TrendSetter]

I have a ls2 t56 and ive been playing with it for a couple weeks, getting it all working pretty well but no matter what i do i cant seem to get dfco to activate. I spent an entire saturday flashing and reflashing my pcm and was never able to get my ipw below about 1.7.
On the way to work today i was playing around and it looks like it activated for a second but i cant figure out why.
I have all the settings suggested in another thread.
any help is greatly appreciated.

log and tune attached.
frames 12522-12536 is the only time ive ever seen the bpw below 1.7ish

14375
14374

[joecar]

You have a M6...?

If so, then you have DFCO disabled, look at all of these:
- B3308
- B3309
- B3310
- B3311
- B3312

you have all of those set to prevent DFCO.

[TrendSetter]

Yes, i have an m6.
After reading around on here i was under the impression that the m6 values you listed were related to dfco during shifting only. I disabled them and reverted to values i found here out of desperation. attached is an earlier log and tune that has the m6 values set to what i believe is 'correct'

edit: frame 624 of this log drops the ipw down to .8 but i cant figure out why it only does it for one frame and never again?

14376
14377

[TrendSetter]

well, that's embarrassing.
Attached is a working log and tune for anyone in the future having this problem.

14379
14380

[joecar]

No worries, glad you got it going, thanks for posting your file.