Logging issues with NGK AFX

[Always2Slow]

Well i just recently purchased efi live not to long ago and did an enormous amount of reading and think i understand the software a decent bit for being very new at this. I have read many of the tutorials and have already tuned out my engine codes that are not needed. My issue lies with Calc.VET tuning. When i start to monitor logging after i have all the calc.vet pids selected i receive an error of something along the lines of error 3$ or something like that. That is with the wideband hooked up when i start logging. When i unplug the wideband and start logging i can plug it back in the AD1 location and everything seems fine. Anyone able to shed some light on whats going on? BTW before anyone asks i did modify my WO2.ben so its correct for my NGK wideband.

[joecar]

Can you pot a screenshot when the error happens...

are you logging from V7 or V2...?

Which year/model/vehicle...?

Which V7 and V8 build versions...?

[Always2Slow]

Everything is up to date with firmware and software and the boot block build 211 on 7.5 and build 203 on v8. I am using scan tool 7.5 for logging which goes from my laptop through the v2 which is hooked into my WB through AD1 and then the v2 is connected to my car. 2000 m6 camaro flashed to 2002 os

Will post a SS later today for you.

[joecar]

Did you flash firmware 2.07.35 into yor V2...?

Did you configure BBx and do Program All to your V2...?

[Always2Slow]

I did update the bbx and firmware but maybe i didnt configure it i have clicked program all before.

[Always2Slow]

Just wanted to update this that i did program all and selected the pids i was going to use and it works fine on the scanner but some of the calc pids arent selected so when i go to logging on 7.5 i get the error again ill screen shot it for you in a minute.

[Always2Slow]

14398

[joecar]

Releated thread: Error-5-response-4-(analog-wideband-logging) (http://forum.efilive.com/showthread.php?21186-Error-5-response-4-(analog-wideband-logging))