PDA

View Full Version : Not entering PE Mode



oztracktuning
March 19th, 2006, 11:34 AM
I noticed yesterday my car is not entering PE mode using 129003
I have it to enable at 95% TP. But the desired AFR is following the table that specifies AFRS at MAP and RPM. I was hoping to be able to fine tune WOT AFRS using the PE table and its own IAT correction.

turboberserker
March 19th, 2006, 12:47 PM
Is your MAP enable set low enough?

TAQuickness
March 20th, 2006, 02:08 AM
For some reason, I seem to recall the PCM will take the richest of the two values (commanded or PE) and apply it when entering PE. Don't hold my feet to the fire on that one though.

ringram
March 20th, 2006, 10:11 AM
My understanding too. Will take richest.

However for NA apps word is that running a map only PE works good.
You can fuel off B3647 solely. Forget TPS, no point.

oztracktuning
March 20th, 2006, 07:01 PM
I was hoping to use the PE mode so that i can use the extra IAT correction with it.

It worked today, it takes the richest it seems.

ringram
March 21st, 2006, 01:35 AM
Ok cool. Does A00014 not work properly while in PE?