Behold
March 31st, 2013, 12:32 AM
Unlike some injector data on the banish DVD the 60# long Siemens don't have a point where its the same figure on the high end. Should I just use the largest figure and flatten it as shown on the DVD or should I calculate it all the way to 0 and fill it in???
I guess it's not shown to calculate it to make it easier for the average joe?
I guess what I'm asking is:
Will it make any difference or are them figures not used much?
Should all injectors be linear line from 0 axis to 0 value or does it flat line at the start?
Do I make sense????
I guess it's not shown to calculate it to make it easier for the average joe?
I guess what I'm asking is:
Will it make any difference or are them figures not used much?
Should all injectors be linear line from 0 axis to 0 value or does it flat line at the start?
Do I make sense????